a. Jammer arrays.
Thomas D. MacDonald 21, a fellow in the Nuclear Policy Program at the Carnegie Endowment for International Peace. He has an interdisciplinary scientific background which he applies to interesting technical problems which are interwoven with political concerns. June 2021, “Hide and Seek: Remote Sensing and Strategic Stability,” Massachusetts Institute of Technology, accessed online via UMich libraries
Stationary Jammer Arrays A jammer array is a collection of jammers which are used to collectively deny radar operations in an area. Taking advantage of the huge disparity in the 𝐽𝑆𝑅, jammers can reach signal-equivalence at very modest powers and gains. If attempting to jam multiple satellites at once, jammers could be directed to cover the entire upward facing 2𝜋 steradian. More complicated arrays could use directed apertures, such as parabolic dish reflectors, to directly illuminate overflying satellites. These would be more complex and costly, but would avoid inadvertently jamming other systems. A jammer array could be conceived of on two scales, jamming a local area and overcoming array adaptation. The more modest approach is to jam radar operations in a local area. This could be accomplished by distributing a number of low-power jammers in an area where the hider wishes to deny the seeker the ability to observe.20 One possibility would be to mount these jammers on shelters. If the shelter spacing 𝑠 is similar to or less than the beam swath width, then this would prevent the seeker from observing those shelters, or the avenues between them. The jammers could be run continuously, or toggled. If run continuously, the area spanned by the local jammer array would be a permanent gap in coverage. In effect, this would create a single distributed shelter where the TEL could operate without risk of being detected, so long as the jammers were operating. If toggled, the jammers could be turned on when a TEL deployed to the local area, kept on for long enough for the TEL to be able to move anywhere within the local jammer array area.21 The jammers could then be toggled off and the seeker would not know which of the shelters covered by the jammer array housed the TEL. The TEL could remain in that shelter throughout its patrol lifetime without needing to move. This would change the dynamics of how the seeker’s uncertainty would accrue over time. Rather than organically accruing over time, the seeker’s uncertainty would grow linearly with time proportional to TEL velocity from when the jammer array was activated until the array was deactivated or the boundary of the jammer array was reached. The hider would have a strong incentive not to move after this point (so as not to risk detection) so the uncertainty would not necessarily grow thereafter. Utilizing a local jammer array, the hider has the ability to generate positional uncertainty effectively on demand, limited only by the costs of emplacing the jammers, and the provocativeness of utilizing them (discussed below). One such array would be needed for each TEL patrol to be protected.