Free beta access. 50 free AI tokens each week. Optional top-ups available. See what is included
Opening Word document…

But, firestorms a myth anyway

Cook 6, Nigel B. PhD Computer Programming BA Physics “Ignition of fires by thermal radiation exposure” http://glasstone.blogspot.com/2006/04/ignition-of-fires-by-thermal-radiation.html 4/7/06

'The density of initial ignitions in the main fire zone, for UK houses, is likely to be very roughly one house in thirty, with a fire-spread factor of about 2 [i.e., each initial ignition will on average ignite one other building by thermal radiation, wind blown convection flames, and hot burning firebrands]. About one house in fifteen is expected to become burnt out. This situation would not constitute a "firestorm" or "mass fire", and the number of fire casualties should be small.' Firestorms have always required at least 50% of buildings to be ignited. A 71 pages long report by Robert M. Rodden, Floyd I. John, and Richard Laurino, Exploratory Analysis of Fire Storms, Stanford Research Institute, California, report AD616638, May 1965, identified the following parameters required by all firestorms: (1) More than 8 pounds of fuel per square foot (40 kg per square metre) of ground area. Hence firestorms occurred in wooden buildings, like Hiroshima or the medieval part of Hamburg. The combustible fuel load in London is just 24 kg/m2, whereas in the firestorm area of Hamburg in 1943 it was 156 kg/m2. The real reason for all the historical fire conflagrations was only exposed in 1989 by the analysis of L. E. Frost and E.L. Jones, ‘The Fire Gap and the Greater Durability of Nineteenth-Century Cities’ (Planning Perspectives, vol. 4, pp. 333-47). Each medieval city was built cheaply from inflammable ‘tinderbox’ wooden houses, using trees from the surrounding countryside. By 1800, Britain had cut down most of its forests to build wood houses and to burn for heating, so the price of wood rapidly increased (due to the expense of transporting trees long distances), until it finally exceeded the originally higher price of brick and stone; so from then on all new buildings were built of brick when wooden ones decayed. This rapidly reduced the fire risk. Also, in 1932, British Standard 476 was issued, which specified the fire resistance of building materials. In addition, new cities were built with wider streets and rubbish disposal to prevent tinder accumulation in alleys, which created more effective fire breaks. (2) More than 50% of structures ignited initially. (3) Initial surface winds of less than 8 miles per hour. (4) Initial ignition area exceeding 0.5 square mile. The fuel loading per unit ground area is equal to fuel loading per unit area of a building, multiplied by the builtupness fraction of the area. E.g., Hamburg had a 45% builtupness (45% of the ground area was actually covered by buildings), and the buildings were multistorey medieval wooden constructions containing 70 pounds of fuel per square foot. Hence, in Hamburg the fuel loading of ground area was 0.45*70 = 32 pounds per square foot, which was enough for a firestorm. By contrast, modern cities have a builtupness of only 10-25% in most residential areas and 40% in commercial and downtown areas. Modern wooden American houses have a fuel loading of 20 pounds per square foot of building area with a builtupness below 25%, so the fuel loading per square foot of ground is below 20*0.25 = 5 pounds per square foot, and would not produce a firestorm. Brick and concrete buildings contain on the average about 3.5 pounds per square foot of floor area, so they can't produce firestorms either, even if they are all ignited.

Sign in to recut, update, or save this card.