How the super chimney works
Ming et al ’14 (Tingzhen Ming and Wei Liu School of Energy and Power Engineering, Huazhong University of Science and Technology, Wuhan 430074, China, Renaud de Richter and Sylvain Caillol Institut Charles Gerhardt Montpellier − UMR5253 CNRS-UM2 − ENSCM-UM1 – Ecole Nationale Supérieure de Chimie de Montpellier, 8 rue de l’Ecole Normale, 34296 Montpellier Cedex 5, France “Fighting global warming by climate engineering: Is the Earth radiation management and the solar radiation management any option for fighting climate change?” Renewable and Sustainable Energy Reviews vol. 31 p. 792-834 sec. 6.4. https://www.sciencedirect.com/science/article/pii/S1364032113008460)//ahigh
The super-chimney imagined by Pesochinsky [150], [154] consists in a huge vertical open duct at both ends, which works as a giant vacuum cleaner, transferring hot air from the sea level to the atmosphere 5 km higher, where temperature is −30 °C. The principle consists in the chimney effect based on the fact that hot air rises by buoyancy above cold air, because hot air is less dense and therefore lighter than cold air. But the process can be made more intense preventing the mixing of warm and cool air, so a chimney prevents inside air from mixing with the outside air until the air exits. The chimney stack effect needs a differential of temperature between the air inside and outside to run correctly. Moreover, the higher the chimney is, the more efficient it is.
It is a similar concept to previously described SCPP [148], except that there is no solar collector at the bottom of the tower, which usually couples the GH effect to the sucking effect of the chimney. According to Pesochinsky the temperature difference between the bottom and the top of the tower is sufficient. Another difference with conventional SCPPs concerns the size, 5–10 times bigger: up to 10 km high with a diameter of up to 1 km. Even if these heights have never been reached by human buildings, some GE / CE projects reported in the initial part of this review envisioned similar heights [59], [60], [61], [62], [63], [64], [65].
Furthermore, some authors reported, with such a large duct and in certain atmospheric conditions, that a cold air inflow could occur at the top and as a result a layer of cold air could get out at the bottom of the chimney, the hotter air surface being just pushed up, with the creation of a thermal inversion. In terms of heat transfer the result is nearly the same: cold air down and hot air up.